User`s manual

7-43
Any one of the following error messages can appear on a data
record display:
Figure 7-10 shows an example of a data record display for
successful run.
“Setp Error” This message will appear if the setpoint
was not reached in a reasonable period of
time.
“Prog Error” This message will appear if, when you ran
an AUTO program, either time became a
negative number or the temperature went
out of the range of 0.1° to 99.9 °C.
“Temp Error” This message will appear if, at the end of
a segment, the set-point temperature
drifted
+/−
a previously entered amount.
See “Changing the Allowed Setpoint
Error” in this chapter.