User`s manual

7-28
Changing the Sample Tube Type
The Configuration function lets you specify a future sample tube
type by defining the tube time constant characteristics. We
recommend not specifying a special tube type unless future
sample tube types become available.
To change the sample tube type and sample tube time constant
value:
1
Select CONFIG on the Utilities menu as described on page 7-3.
The following display appears:
2
Press
ENTER
, then press
STEP
six times.
The following display appears:
This display lets you specify a special type of sample tube when
you start a run if you are not using MicroAmp Reaction Tubes or
Thin-Walled GeneAmp Reaction Tubes. The default condition of
this parameter is no special tube type, as indicated on the display
by “NO.”
3
If you accept the default condition, you will be able to select one of
two standard sample tube types when you start a run (MicroAmp
Reaction Tubes or Thin-Walled GeneAmp Reaction Tubes).
Configuration
E
DIT-PRINT
Special tube? NO