User`s manual

7-22
Changing the Pause Time-Out Limit
The
pause time-out limit is the maximum amount of time a
program can pause before it automatically aborts; it applies only
to the keypad pause. The default value is 10 minutes. This
means that if you do not restart a run within 10 minutes after you
pause it, the run is aborted. The Configuration function lets you
change the pause time-out limit.
To change the pause time-out limit:
1
Select CONFIG on the Utilities menu as described on page 7-3.
The following display appears:
2
Press
ENTER
, then press
STEP
twice.
The following display appears:
The default value of ten minutes and zero seconds (10:00) appears
on this display. The acceptable range for the pause time-out limit is
0 to 99:59 minutes.
3
To change the pause time-out limit, press the appropriate numeric
keys, then press
ENTER
. The display will automatically place the
colon for you.
Note
For practical purposes, the pause time-out should be at least
one minute.
4
Press
STEP
to display the next configuration parameter or press
BACK
to display the previous configuration parameter. Press
STOP
to return to the first Configuration display.
Configuration
E
DIT-PRINT
Pause time-out limit
10:00