User`s manual

6-17
Run-Time Displays
During a run, you will see a run-time display that is continuously
updated for the program being run.
CYCL and AUTO Program Run-Time Displays
The run-time displays for a CYCL program and an AUTO
program are the same. If you are in a ramp segment, the display
will show “Ramp to. . .” If you are in a hold segment, the display
will show “Hold at. . .” These displays are shown in Figure 6-9.
Figure 6-9
Run-time displays for a CYCL program.
Once a CYCL or AUTO run has started, press the
MORE
key to
view a second run-time display (see Figure 6-10). This run-time
display includes further information about the run.
Ramp to 94.0C xx.xC
0:00 Cycle 1
Current cycle #
(counts up cycles
during a run)
Setpoint temperature
Time remaining
Current sample
temperature
Hold at 94.0C xx.xC
0:12 Cycle 1
Current cycle #
(counts up cycles
during a run)
Setpoint temperature
Time remaining
Current sample
temperature