User`s manual

6-14

♦

If you have a printer and it has been enabled (using the

Configuration function), the following display appears:

This display lets you select the type of printout you want:

Press the

OPTION

key to choose one of these print options. When

the cursor is under your desired option, press

ENTER

The following display appears:

Make sure the heated cover is closed and tightened down. After a

few seconds, the run starts.

Select print mode

FF-CYCLE-SETPOINT

OFF: Disables data output to the printer for this run.

CYCLE: Prints a message that reads “Complete” after each

cycle.

SETPOINT Prints actual and programmed time and

temperature data for each ramp and hold segment

during cycling. See Figure 6-8 for an example

Setpoint printout of a Cycle program.

Close and tighten

the sample cover