User`s manual

6-5

Placing the Sample Tray in the Block

Lift the sample tray and retainer assembly from the sample tray

base and place it in the sample block. Make certain that the notch

in the sample tray is at the left of the block. The receptacle in the

tray labeled A1 will then be in the upper left-hand corner of the

block. Once the tray is placed in the block, be sure that the rim of

the tray engages with the channel around the block.

Figure 6-3

Placing the sample tray in the block.

CAUTION

Do not place the MicroAmp Base in the sample block.