User`s manual

5-44
The display appears only if you specified a pause in
the previous display. In this display, you define the
setpoint after which you want to pause the run. Type
the number of the desired setpoint, then press
ENTER.
During the pause, you specify whether or not you
want a beeper to sound. Press the OPTION key to
change the YES (default) to a NO and vice versa.
When the de-sired response is displayed, press
ENTER.
This display only appears if you specified a pause
during the run. In this display, you specify the
number of the cycle in which you want the run to
pause. The default value (1) indicates that the
instrument will pause during the first cycle (after the
specified setpoint). Press the number of the desired
cycle, then press ENTER.
Next, you specify how often the pause should occur.
The default value will be the same value as the total
cycles in the program. This indicates that the
instrument will pause only once during the run. To
pause more frequently, change the default. For
example, to pause every cycle, you would press 1.
To pause every other cycle, press 2. After you
specify the number, press ENTER.
This display only appears if you specified a pause
during the run. In this display, you specify how long
the instrument should pause. Specify the pause
time in minutes and seconds, then press ENTER.
Pause after setpt #1
Beep while pause?YES
1st pause at cyc 1
Pause every 25 cyc’s
Pause time 10:00