User`s manual

3-26
7
Press
MORE
again to return you to the first run-time display. The
illustration below shows you how the
MORE
key works.
8
After a few moments, press the
STOP
key to abort the run.
The following display appears:
9
Press the
ENTER
key to stop the program.
A display similar to the one shown below appears:
O
Setpt #1 Tot Cyc 30
Hrs left 0.7 Prog 1
Current program #
Estimated time left in
Total cycles in program
Current setpoint number
program
More
Press
To move between
the two run-time dis-
plays
O
Ramp to 96.5C xx.xC
0:30 Cycle 1
Setpt #1 Tot Cyc 30
Hrs left 0.7 Prog 1
CYCL# 1 xx.xC
Abort program? YES