Service manual

PG-C30XE

No. Adjusting point Adjusting conditions Adjusting procedure

30 RGB

performance

check

1. Receive the RGB signal. » In the process mode and select L4. Check the pic-

ture, brightness, red, blue, clock, phase, horizontal

position, and vertical position.

31 Off-timer

performance

check

» In the process mode and select OFF. Make sure that

the off-timer starts with “5” (minutes), counts down each

minute in 1 second, and turns off the set at “0”.

32 Thermistor

performance

check

1. Heat the thermistor using a

dryer.

» Make sure the “TEMP” is displayed.

33 Automatic

synchronization

1. Receive the PHASE check

pattern signal.

» Call the VGA/SVGA/XGA/SXGA mode and make

sure that the clock, phase, horizontal and vertical

positions can be automatically adjusted.

34 Keystone

correction

performance

check

» Make sure the keystone correction functions well.

35 Factory settings » Make the following settings.

Process

adjustment

Remote controller

setting

S3 “Factory setting 3”