Service manual

Stylus C40UX/C40SX/C20UX/C20SX Revision B
Disassembly and Assembly Disassembly 76
4.2.10 LD unit removal
1. Remove the upper housing. (Refer to Section 4.2.1)
2. Remove the ASF unit. (Refer to Section 4.2.2)
3. Disconnect the cables which are connected to the LD unit.
4. Disconnect connector CN4 form the MAIN board.
Figure 4-38. Disconnecting the Cables
5. Push the two hooks on the LD unit, then lift it up and remove hook of pump unit
Figure 4-39. Removing the LD unit
LD unit
Cables
Hooks
 When reassembling the LD unit, make sure that seven hooks are
set to the Main frame.
Figure 4-40. Setting seven hooks
A D J U S T M E N T
R E Q U I R E D
The Top Margin adjustment is required when the LD unit is
replaced.