Quick Start Guide
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
69
Chapter 3 Setup of the Printer
5
Select the printer to be paired, and then click [Connect].
6
If the window to enter a passkey appears, enter a passkey and click [OK].
7
Select the port to be used from the pull-down list, and then click [OK].
8
The “Connection complete” window appears. Click [Test Buzzer] or [Test Printing] to
check operation.
9
Click [Back to Main screen] to return to the main window.
10
Click the “x” button of TM Bluetooth® Connector to exit.
• If “Error” is displayed when you click the [Search] on the TM Bluetooth® Connector, check
whether:
*The Bluetooth adapter is installed to the computer.
* Bluetooth is ON in the Windows settings.
• If the device is not displayed on the TM Bluetooth
® Connector or the TM Bluetooth® Connector
Status shows “ ” after pairing.
Check whether:
* The printer is not turned on.
Turn on the printer.
* The printer is 10 m or further away from the computer.
* Confirm that there is no other wireless device, such as a microwave oven and cordless
telephone, that can interfere with the Bluetooth printer.
* If the printer and the computer are placed in different rooms separated by a wall, move the
printer and/or the computer in the same room.
* The printer may not be detected when the search time is short. Try search again with longer
search time.
* While a computer and printer are communicating, the printer cannot be detected by other
computers. Confirm that the printer to be detected is not communicating with any
computer.