Quick Start Guide
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
161
Appendix
Bluetooth low energy technology Advertising Packet specifications
Format: cmd 0x08 0x0008 d1 d2 … d32
Function: Sets the Data for the Bluetooth low energy technology Advertising packet.
Specify all from d1 to d32. If these are not necessary, specify 00 for each one.
Definition Length Default (iBeacon) Description
Advertising data length 1 byte d1: 1e 1eh: 30bytes
Advertising Data 31 bytes d2: 02
d3: 01
d4: 06
d5: 1a
d6: FF
d7: 4c
d8: 00
d9: 02
d10: 15
02h: Length
d11-d26:
fa c1 ba 2f 61 a2 4d 83
9a 8c 60 08 7c 23 25 69
TM UUID
fac1ba2f-61a2-4d83-9a8c-
60087c232569
d27: 00
d28: Model No.
Major number
The Default specifies the ID that
indicates the model type using
keywords shown in "Keywords" on
page 162
.
Y
ou can also specify a direct value.
d29: 00
d30: IP address 4th byte
Minor number
The Default specifies the 4th sector of
the IP address using keywords shown
in "Keywords" on page 162.
Y
ou can also specify a direct value.
d31: BD BD: -67dB
d32: 00 00h: Fixed value