User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
89
Chapter 5 Advanced Usage
Communication condition of USB interface
Class
• USB printer class (initial setting)
• USB vendor-defined class
Communication condition of Bluetooth interface
• Device name (initial setting: TM-m30II-SL_xxxxxx)
• Passkey (initial setting: 0000)
• Security (initial setting: Low)
• Auto Re-Connect with iOS device (initial setting: Enabled)
Bluetooth communication interval during power saving mode
• Level 1 (Standard) (Initial setting)
• Level 2 (Short)
The device name is initially set to TM-m30II-SL_xxxxxx.
(xxxxxx refers to the last 6 digits of the serial number labeled on the back of your printer.)
By changing the setting to "Level 2 (Short)," you can shorten the time until printing begins or the
time until information is shown on the customer display connected to the printer.
However, because the communication frequency increases, the power consumption of the printer
and the host also increases.
Also, depending on the host, this setting may not be enabled, and the host-specified
communication interval may be used.