User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
84
Chapter 5 Advanced Usage
Paper width
• 80mm (initial setting)
• 58mm
Print density
Selectable from 70% to 120% (5% increment)
Initial setting: 100%
Depending on the paper type, it is recommended to set the print density as shown in the table below for the best
print quality.
Print speed
Selectable from levels 1 to 13 (Slow ~ Fast)
Initial setting: level 13
Thai characters print mode
• Thai 1 pass (initial settings)
• Thai 3 pass
Character code table defaults
Selectable from 43 pages including user defined page
Initial setting: PC437: USA, Standard Europe
International character defaults
Selectable from 18 sets
Initial setting: USA
Supported papers Print density
TF50KS-EY, TF60KS-E, PD160R,
PD190R, P220AGB-1, AP45KS-ND,
AP50KS-ND, KT55PF
100%
P5047(48) 105%
KT48FA, KT55FA, KT48PF, P5047(55) 110%
When the print density level is increased, print speed may be reduced.
Depending on print conditions, such as print duty, print head temperature, and data transmission
speed, print speed is automatically adjusted, which may cause white lines due to intermittent print
(the motor sometimes stops). To avoid this, keep the print speed constant by setting it lower.