User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
76
Chapter 4 Using Dedicated Optional Products
Adjusting the Display Brightness
The brightness of the display can be adjusted by pressing the brightness up/down buttons. There are four
brightness levels. It is set to the brightest setting by default.
Cleaning the Outer Case
When cleaning the outer surface of the customer display, make sure to turn off the printer in advance, and then
wipe dirt off with a dry cloth or a cloth slightly moistened with water.
Product Specifications
• Never clean the product with alcohol, benzine, thinner, or other such solvents. Doing so may
damage or break the parts made of plastic and rubber.
• Rubbing the LCD screen with too much force using a dry cloth may scratch the surface.
Display size 7 inch (800 x 480 pixels)
Display type TFT LCD (16.2 million colors)
Power supply USB bus power
Consumption current Operating 0.5 A (max.)
Temperature / Humidity Operating 5 to 45°C {41 to 113°F}, 10 to 90%RH, no condensation
Storage -10 to 50°C {14 to 122°F}, 10 to 90%RH, no condensation
Altitude 3,000 m or less
Dimensions 180 x 140 x 105 mm {7.1 x 5.5 x 4.1"} (W x D x H)
Weight Approx. 0.58 kg {1.28 lb}
The display functions of OT-DM30SL are the same as DM-D70. For details about the display
functions, see the user’s manual for DM-D70.
U www.epson-biz.com/?prd=dm-d70&inf=manual