User Manual

22
Chapter 1 Product Overview
*1: To detect this status (remaining amount of roll paper is low), enable the "Roll paper near-end detection"
function. The function can be used when placing the printer vertically and using 80 mm width roll paper.
For more details about the detection setting, see "Software Settings" on page 81. For more details about near-
end
detection, see "Enabling the Roll Paper Near-End Detection" on page 71.
*2:
The Error LED flashing pattern is: turning on and off alternately at 320 ms intervals for five seconds, then
goes off.
*3: The Power LED flashing pattern is: lighting for 320 ms followed by a pause for 320 ms.
*4: The Power LED flashing pattern is: lighting for 160 ms followed by a pause for 2400 ms.
*5: The Power LED flashing pattern is: lighting for 4960 ms followed by a pause for 160 ms.
Bluetooth Connection Status
O: OFF N: ON F: Flashing -: Ignore the LED light
* The LED flashing pattern is: lighting for 320 ms followed by a pause for 320 ms.
FOFO O O
While forced updating firmware mode is
on
F *3 N O O O O During turn-off process
F *4 OOO O O
During power off
NOTE:
The printer enters this status while pro-
cessing the power off command. It is
recommended to use this method
when you need to save information on
the printer’s operating status if the
power is cut without using the power
switch.
F *5 O -- - -
A warning about TM-Intelligent
function
Power
LED
Error
LED
Paper
LED
Wi-Fi
LED
Ethernet
LED
Bluetooth
LED
Printer Status
NOO -- F Waiting to be paired with a device
NOO -- N Connecting via Bluetooth
NOO -- O Not connected via Bluetooth
Power
LED
Error
LED
Paper
LED
Wi-Fi
LED
Ethernet
LED
Bluetooth
LED
Printer Status