User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
21
Chapter 1 Product Overview
Status and Errors
The status of the printer is indicated by lit and flashing LEDs.
Status Display
O: OFF N: ON F: Flashing -: Ignore the LED light
You cannot print when an error has occurred.
You cannot identify the error by the flashing patterns of the LEDs. Develop the application so that
users can identify the error description and check the solutions.
Power
LED
Error
LED
Paper
LED
Wi-Fi
LED
Ethernet
LED
Bluetooth
LED
Printer Status
NOO -- -Online
NNNN N N
While initializing after turning on the
power
NO - OO ODuring a self-test
NO -- - -
While feeding paper using the Feed
button
NN -- - -
Roll paper cover open while not print-
ing
NOFO O OWaiting for the self-test to continue
NOF - - - Waiting for a Macro execution to run
NNF -- -
Waiting for the roll paper cover to be
closed to print a status sheet.
NNN - - - No roll paper
NON - - - Remaining amount of roll paper is low*
1
NN -- - -
Automatically Recoverable Errors
Recoverable Errors
N F *2 - - - -
The connected device can only be
charged through the USB port.
N F - OO O
Unrecoverable Errors
CAUTION:
Turn off the power immediately when
an unrecoverable error occurs.
If the same error occurs again even after
turning the power back on, contact
qualified service personnel.
FOOO O OUpdating firmware