User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
153
Appendix
Digest authentication
You need Digest authentication to communicate with the printer.
The default ID and Password are ID: epson, Pass: serial number and are the same as the administrator for
Network settings.
Escape processing for configuration scripts
When reading/writing a configuration script for a printer, the strings (content of the configuration script) being
transmitted and received uses the following escape processing. However, escape is not performed for uXXXX
(hexadecimal strings) such as Japanese.
Table 2 Escape Processing
Acquiring the configuration script from the printer using an HTTP request
A response for the json format is acquired using the GET method for the HTTP request.
Request
Table 3 Request Header
Table 4 Types
Escape Description
\” quotation mark
\\ reverse solidus
\b backspace
\f form feed
\n line feed
\r carriage return
\t tab
\u002F solidus
\u003C <
\u003E >
\u002B +
Request header: Content-Type: text/plain; charset=utf-8
http://(printer IP address)/webconfig/beacon.cgi?Type=(one of the following Table 4 Types)
Type Description
(none) If a Type is left out, the same operation is performed as when current is specified.
current Specifies the currently enabled configuration script.
volatile Specifies the configuration script stored in RAM.