User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
151
Appendix
Bluetooth Low Energy Technology Advertising
Introduction
When you connect the BT820 from Laird Connectivity to the USB A connector on the TM-m30II-SL and turn
it on, the Bluetooth low energy technology Advertising Packet is transmitted. By default, the TM-m30II-SL
transmits the packet according to the iBeacon Format from Apple. You can also change the data that is
transmitted by following the steps in "Changing the Bluetooth Low Energy Technology Advertising Packet" on
pag
e 152.
Glossary:
Dongle specifications
Manufacturer: Laird Tech
Model name: BT-820
For setting methods and settings, see the TM-m30II Utility User's Manual.
Procedure
When you install the Bluetooth adapter, the printer is restarted and then the adapter is enabled.
When you uninstall the Bluetooth adapter, the printer is restarted and then the adapter is disabled.
The USB-A – Device Charging port is disabled.
If the printer is capable of Bluetooth communication, the Bluetooth function is disabled.
Term Description
Bluetooth Low Energy Technology Advertising The name of this function.
Bluetooth Low Energy Technology Advertising
Packet
The data sent by this function from the printer.
Bluetooth adapter The BT820 from Laird Connectivity.
A USB dongle to connect to the USB Type A connector.
iBeacon The format stipulated by Apple for Bluetooth low energy
technology Advertising Packets
When using the default settings for the TM-m30II-SL (Bluetooth
adapter installed in the printer and the printer is on), the Bluetooth
low energy technology Advertising Packet is transmitted in
iBeacon format.