User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
150
Appendix
Solution
Do not send data to the printer if the printer is not ready to print.
For developers using the SDK from Epson, see the User's Manual - Chapter 3 Programming Guide - "Printing
After Checking the Printer Status".
Since Bluetooth is disconnected when this occurs, if the auto reconnect feature is not enabled, you need to
reconnect from the Bl uetooth settings screen on the iOS device.
When using the SDK from Epson, this connection process is not necessary.
The iOS application cannot receive the data sent from the printer
Situation
Although the printer sends data to the iOS device and the data is received by the iOS device, depending on the
combination of the iOS version and the iOS device, the iOS application may not be able to receive the data.
Conditions
This may occur in combinations of the following conditions.
• iOS version: 7.1, 7.1.1
• iOS device: iPhone 5s, iPhone 5c, iPhone 5, iPad Air, iPad mini 3, iPad (4th generation), iPad mini, iPod
touch (5th generation), iPhone 4s, iPhone 4, iPad (3rd generation), iPad 2
• Application processing: If the Bluetooth port is closed and then reopened while the application is running.
Solution
The solution differs depending on the iOS device being used. See the following table.
iOS Device Solution
iPhone 4s
iPhone 4
iPad (3rd generation)
iPad 2
This situation can be avoided by using the Epson ePOS SDK for iOS.