User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
15
Chapter 1 Product Overview
Part Names and Functions
Front
1 Upper tablet holder Holds the upper side of a tablet.
2 Tablet table (standard) Place a tablet on this table.
3 Lower tablet holder Holds the lower side of a tablet.
4 Security slot Use here to attach an anti-theft tool such as a wire. This slot is provided on both sides
of the printer.
5 Lock lever Operate this lever to secure a tablet.
6 Screw The screws are securing the tablet table.
7 Cover open lever Operate this lever to open the roll paper cover.
8 Feed button Press this button once to feed the roll paper for one line. Hold down this button to
continue feeding the roll paper.
9 Power switch This switch turns the printer on or off.
10 Roll paper cover Open this cover when installing or replacing the roll paper.
11 Panel LED For explanation of the LEDs, see "Panel LED" on page 17
When turning off the printer without using the power switch, it is recommended to send a power-
o
ff command to the printer. If you use the power-off sequence, the latest maintenance counter val-
ues are saved. (Maintenance counter values are usually saved every two minutes.)
For information about ESC/POS commands, see the ESC/POS Command Reference.
1
2
3
4
5
6
7
8
9
10
11