User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
147
Appendix
Bluetooth Interface
Specification
• Bluetooth 3.0 (EDR supported)
• Bluetooth Power Class 2
• Built-in antenna
• Pass key setting is possible
• Device name setting is possible
• Pairing information of up to 8 devices can be registered
Initial Settings
Auto Reconnect Feature
The auto reconnect feature allows the printer to automatically restore a connection in the following situations if
the Bluetooth connection to the iOS device is lost.
• When the printer is turned on
• When the signal is dropped and then restored
The following shows the printer operations and connection methods when the auto reconnect feature is enabled
or disabled.
Countries where Bluetooth can be used are limited. Since notes are provided for each country, check
the sheet supplied with the product.
Setting Contents Setting Items Initial Settings
Bluetooth communication
settings
Bluetooth passkey "0000"
Bluetooth device name "TM-m30II-SL_xxxxxx"
(Where xxxxxx is the last six digits in the serial
number)
Bundle Seed ID "TXAEAV5RN4"
Enable/Disable auto reconnect to
iOS device
"1" (Enable)
Bluetooth Security Low
Bluetooth communication interval
during power saving mode
Level 1 (Standard)