User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
136
Appendix
Paper Specifications
Paper width 58 mm Paper width 80 mm
Paper types Specified thermal paper
Form Roll paper
Size Roll paper diameter 83 mm {3.27"} maximum
Roll paper core Outside: 18 mm {0.71"}
Roll width when taken up 58 + 0.5/-1.0 mm {2.28 + 0.02/-0.04"} 80 + 0.5/-1.0 mm
Paper width 57.5 ± 0.5 mm {2.26 ± 0.02"} 79.5 ± 0.5 mm
Paper thickness Maximum of 80 μm, minimum of 48 μm
Specified original paper type TF50KS-EY, TF60KS-E NIPPON Paper Industries Co., Ltd.
PD160R, PD190R OJI Paper Mfg. Co., Ltd.
P220AGB-1 Mitsubishi Paper Mills Limited.
AP45KS-ND, AP50KS-ND Jujo Thermal Oy
F50417(55), F50417(48) Mitsubishi HiTec
KT55FA, KT48FA, KT55PF, KT48PF Koehler Paper Group
• Paper must not be pasted to the roll paper core.
• To keep the print quality, it is recommended to change the print densities for each roll paper.
See "Software Settings" on page 81.
• U
se of thermal paper with a pre-printed recording surface should be avoided. Using it can cause
the thermal head to stick to the thermal paper surface during printing, and cause printing
failure and other problems. The pre-printing also can result in reduced print density. Using
thermal paper with a pre-printed recording surface, pre-printing should be done in accordance
with the conditions (ink type, printing and other conditions) recommended by the paper
manufacturer, and the thermal paper should be checked to ensure that there is no faulty
printing, loss of print density, or other problems.