User Manual
Table Of Contents
- For Safety
- Restriction of Use
- Note about interference
- Open Source Software License
- About this Manual
- Contents
- Product Overview
- Setup of the Tablet
- Setup of the Printer
- Flow of Setup
- Placing the Printer
- Changing the Paper Width
- Connecting Peripheral Devices
- Connecting the Wireless LAN Unit
- Connecting the Customer Display
- Connecting the Optional External Buzzer
- Connecting the Cash Drawer
- Connecting to the Power Source
- Connecting the Printer to the Host Devices
- Attaching the Power Switch Cover
- Enabling the Roll Paper Near-End Detection
- Using Dedicated Optional Products
- Advanced Usage
- Software Settings
- Functions
- Receive buffer capacity
- BUSY condition
- Auto line feed
- USB power-saving function
- Release condition of receive buffer BUSY
- Select paper out detector enabled for paper out signal output
- Error signal settings
- Pre-feed before next print
- Roll paper near-end detection
- Network tethering
- Paper width
- Print density
- Print speed
- Thai characters print mode
- Character code table defaults
- International character defaults
- Interface selection
- Column emulation mode
- Command execution during offline
- Amount of top margin by backfeed
- Interface switch waiting time
- Main connection interface
- Autocutting after closing cover
- Paper reduction
- Font A auto replacement
- Font B auto replacement
- Font C auto replacement
- Multi-tone print density
- Optional buzzer
- Batch rotate print (Upside Down)
- Communication condition of USB interface
- Communication condition of Bluetooth interface
- Bluetooth communication interval during power saving mode
- Functions
- Network Settings
- Setting/Check Modes
- Printing a Status Sheet
- Resetting the Interface Settings
- TM-Intelligent Function
- Network Tethering (iOS device only)
- Software Settings
- Application Development Information
- Handling
- Appendix
- Product Specifications
- Specifications of Interface and Connector
- Bluetooth Low Energy Technology Advertising
- Character Code Tables
- Compatibility with USB Type-A
102
Chapter 5 Advanced Usage
Auto re-connect to iOS device
In Bluetooth model, select [Bluetooth Setup] and then select [Auto Re-Connect iOS], you can select whether to
enable or disable auto reconnection to iOS devices.
Bluetooth Security Settings
For Bluetooth models, select [Bluetooth Setup], and then select [Security], and you can change the Bluetooth
security settings.
Pairing method when the security is set to Middle/High (from the printer)
When the security is set to Middle/High and the printer is ready to be paired, perform the following procedure.
1
Load paper in the printer, and then turn it on.
2
Open the roll paper cover, hold down the FEED button (two seconds), and then close
the roll paper cover.
3
A status sheet is printed, and the Bluetooth LED flashes a pattern indicating that pair-
ing is now possible.
• For details on the auto re-connect function, see "Auto Reconnect Feature" on page 147.
• You can change the settings with TM-m30II Utility and TM Utility for iOS.
When the security settings are changed from "Middle" or "Low" to "High", or vice versa, the link key
(pairing information) is deleted. If the printer is already paired with a terminal, unpair them and then
pair again.
You can change the settings with TM-m30II Utility and TM Utility for iOS/Android.
Security Pairing Mode Pairing Method
Low Pairing is always possible Just Works
Middle
(initial setting)
Pairing is possible for one minute after turning the printer on
or after printing the status sheet
Just Works
High Pairing is possible for one minute after printing the status
sheet
Numeric Comparison/Passkey Entry
• Make sure no errors have occurred and that the printer is not off-line.
• You cannot pair the printer while the network is starting up immediately after the power is turned
on.
• Pairing is possible for one minute after printing the status sheet.
• You can enable pairing also by printing the status sheet by pressing the status sheet button.