User Manual

For models with stands, moving the printer on casters
is possible providing there are no steps or unevenness
in the floor along the route, however pay attention to
the following points.
Caution:
For models with stands, ensure that you abide by
the following points in order to prevent damage
from falling over.
❏ Do not move the printer with casters locked
❏ Avoid areas with steps or unevenness
❏ After moving, ensure the casters are locked
before use
c
Important:
Ensure you move and transport the printer with
the ink cartridges installed. Do not remove the ink
cartridges; otherwise, the nozzles may be clogged
and make it impossible to print, or ink may leak.
A
Remove all paper from the printer.
B
Close all covers on the printer. For models with
stands, close the paper basket.
C
Turn off the printer, and unplug all cables,
including the power cord and LAN cables, etc.
D
For models with stands, release the locks on the
casters.
Operations after Moving
This explains operations to prepare for use after
moving the printer.
A
Connect the power cable, and turn the printer
on.
B
Check for print head nozzle clogging, and if
these are clogged, carry out print head cleaning.
U “When you want to unclog the print head”
on page 196
When Transporting
Before transporting the printer, contact your dealer or
Epson Support.
U “Where To Get Help” on page 233
Handling if Transporting/
Leaving the Printer in an
Environment of -10°C or Less
The print head may fail if the environmental
temperature becomes -10°C or lower. Discharge the
ink following the procedures below if you expect the
printer to encounter environments of -10°C or below.
c
Important:
This procedure discharges ink into the
Maintenance Box, therefore the Maintenance Box
requires adequate remaining capacity. If the
remaining capacity box is low, first prepare a new
replacement Maintenance Box.
A
If paper is loaded, remove all paper.
U “Removing Roll Paper” on page 38
U “Removing Cut Sheet (1 Sheet)” on page 41
B
From the Home screen, touch Settings -
Maintenance - Discharging/Charging Ink.
C
Touch Start.
Ink discharging starts, and the power turns off
automatically when it finishes.
c
Important:
Do not open the cover or turn the printer off
during ink discharge.
After this, refer to the following for
preparations for movement/transport.
U “Moving to a Different Location in the
Same Building” on page 225
U “When Transporting” on page 226
SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Appendix
226