User Manual

Backward : The roll is taken up with the printable
side in.
Forward : The roll is taken up with the printable
side out.
Off : The auto take-up reel unit does not
take up paper.
C Manual switch
Selects the manual take-up direction.
The selected option takes effect when the Auto
switch is in the Off position.
Backward : The roll is taken up with the printable
side in.
The speed will increase after the button
is pressed for more than three seconds.
Forward : The roll is taken up with the printable
side out.
The speed will increase after the button
is pressed for more than three seconds.
Attaching the Roll Core
c
Important:
❏ Use a roll core the same size (width and core
diameter) as the roll paper you are printing on.
If the size of the roll core (width and core
diameter) is different, it may not be wound
correctly.
❏ If the roll core is deformed or the surface is
damaged, it cannot be used as a take-up roll
core.
The direction of the flange to the auto take-up reel unit
varies depending on the roll core size (core diameter)
being used.
Attaching the Paper
This section describes how to attach roll paper to the
auto take-up reel unit roll core.
The procedure varies with the take-up direction.
c
Important:
Before proceeding, set Auto Cut to Off. Using the
auto take-up reel unit when On is set causes errors.
U “Cutting the roll paper” on page 25
Taking Up the Paper Printable Side
Out
For information on installing the roll core, see the Setup
Guide for the optional auto take-up reel unit.
A
Set the auto take-up reel unit Auto switch to Off.
Plug the power cord into an outlet and confirm
that the power lamp lights.
B
Turn on the printer.
C
Check that the roll paper is correctly loaded in the
printer.
D
Select Paper loading information - Prepare for
Take-up on the printer's control panel.
The paper is fed to the roll core.
SC-P9500 Series/SC-P7500 Series User's Guide
Basic Operations
39