User Manual

Make custom paper settings on the
control panel
A
Select General Settings - Printer Settings -
Custom Paper Setting on the control panel.
B
Select a paper number from 1 to 30 to save the
settings.
C
Set the paper information.
Make sure you set the following items.
❏ Change Reference Paper
❏ Paper Thickness
❏ Roll Core Diameter (roll paper only)
❏ Paper Feed Offset
See the following for details on the other settings.
U “Menu List” on page 101
When using this from the printer driver, select "Use
Printer Settings" in "Paper Type".
PANTONE Color
Explanation
There are many variables in the process reproduction of
colors generated by the SC-P9500 Series/SC-P7500
Series, any one of which may affect the quality of the
PANTONE Color simulation.
For optimal results, we recommend that the following
driver and materials use.
Print Quality (Printer Driver): Max Quality
Media: Epson Proofing Paper White Semimatte
Ink: Genuine Epson ink
Notes When Moving or
Transporting the Printer
This section describes precaution when moving and
transporting the product.
Notes When Moving the Printer
This section assumes that the product is being moved to
another location on the same floor without traversing
stairs, ramps, or lifts. See the following section for
information on moving the printer between floors or to
another building.
U “Notes on Transporting” on page 171
Caution:
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to observe
this precaution could result in the printer falling
over, causing accidents.
c
Important:
Do not remove the ink cartridges. Failure to observe
this precaution could cause the print head nozzles to
dry out.
Getting Ready
A
Confirm that the printer is off.
B
Disconnect the power cords and all other cables.
C
Place the roll section of the paper basket as shown
in the image.
SC-P9500 Series/SC-P7500 Series User's Guide
Appendix
170