User Manual

About Roll Paper Cutting
When performing borderless printing on roll paper, you can specify whether it is left and right borderless printing or
all edges borderless printing, and how to cut the paper in the printer driver's Roll Paper Option. The cutting operation
for each value is shown in the following chart.
Printer driver
settings
Normal Cut Single Cut Double Cut
Cutting Operation
Explanation
The default printer driver setting
is Normal Cut.
❏ The top area may become
slightly uneven depending
on the image since the print
operation stops while
cutting the top edge of the
roll paper.
❏ If the cut position is
misaligned slightly, small
parts of the image may be
shown on the top or
bottom of the adjacent
pages. If this occurs,
perform Adjust Cut
Position.
U “Maintenance” on
page 112
❏ When you print one page
only or print one page
multiple times, the
operation is the same as
that for Double Cut. When
continuously printing
multiple sheets, the printer
cuts 1 mm inside on the top
edge of the first page and
the bottom edge of the
subsequent pages to avoid
showing margins.
❏ The top area may become
slightly uneven depending
on the image since the print
operation stops while
cutting the top edge of the
roll paper.
❏ The printed paper is
approximately 2 mm
shorter than the specified
size since the printer cuts
the paper inside the image
to avoid showing top and
bottom margins.
❏ After cutting the bottom
edge of the previous page,
the printer feeds the paper,
and then cuts the top edge
of the following page.
Although this produces 60
to 127 mm cut-off pieces,
the cut is more accurate.
SC-P9500 Series/SC-P7500 Series User's Guide
Printing Varieties
72