User Guide

Table Of Contents

181

• Make sure you install your product's network software as described in your product documentation.

• Print a network status sheet and verify that the network settings are correct. If the network status is

Disconnected, check any cable connections and turn your product off and then on again.

• If you are using TCP/IP, make sure the product's IP address is set correctly for your network. If your

network does not assign IP addresses using DHCP, set the IP address manually.

• Make sure your computer and product are both using the same wireless network.

• If network printing is slow, print a network status sheet and check the signal strength. If it is poor, place

your product closer to your router or access point. Avoid placing your product near a microwave oven,

2.4 GHz cordless phone, or large metal object, such as a filing cabinet.

Note: If you are using a 5 GHz wireless router, set the router to operate in dual band (2.4 GHz and

5 GHz) mode. If your router uses a single network name (SSID) for both the 2.4 GHz and 5 GHz band,

give each band its own network name (SSID) instead, such as Home Network 2.4 GHz and Home

Network 5 GHz. See your router documentation or contact your internet service provider for

instructions.

• Check to see if your wireless router or access point has an enabled Privacy Separator function that is

preventing printing from a device over the network. See your router or access point documentation for

instructions on disabling the Privacy Separator function.

• If you are connecting the product wirelessly via EpsonNet Setup and the Wi-Fi connection icon is not

lit or does not appear on the product's LCD screen, make sure your product software was installed

correctly. If necessary, reinstall your software.

Parent topic: Solving Network Problems

Related references

Cannot Scan Over a Network

Related tasks

Printing a Network Status Sheet