Installation Guide

42
7 Attaching the Covers
A Attach the wall plate covers and end cap
If you need to use a security cable, make sure you attach it before installing the wall plate covers. See
page 44 for instructions.
1. Attach the wall plate covers ( ). Snap the tabs on the cover into the holes on the wall plate. (If you
need to remove the cover, press the tabs.)
2. Place the end cap with the concave portion facing up ( ).
Depending on how the cables are wired, you may need to cut out parts of the wall
plate cover to allow the cables to be passed through it.
When cutting the thin section of the wall plate cover and passing the cables through,
make sure you perform deburring to smooth off any sharp edges to prevent damaging
the cables.
Also, make sure you operate the cutter safely.
End cap
Wall plate cover