Installation Guide

62
9 Installing the Control Pad
You must have completed the steps in “Installing the Projector” on page 30 before installing the Control Pad.
Follow the steps below to install the Control Pad and connect to the projector.
Check the installation location
The Control Pad must be installed in the area specified in the diagram below.
Make sure there is enough space surrounding the Control Pad. Because the top panel
opens from the left, there must be additional space to the left of the Control Pad.
The Control Pad should only be connected to the BrightLink Pro 1410Wi/1420Wi/1430Wi. Do
not connect the Control Pad to any other projectors.
Caution
68.9 in.
(1.75 m)
35.4 in.
(0.9 m)
27.6 in.
(0.7 m)
13.8 in.
(0.35 m)
9.8 in.
(0.25 m)
39.3 in. (1.0 m)
59.0 in. (1.5 m)
78.7 in. (2.0 m)
78.7 in.
(2.0 m)
60-inch
image
100-inch
image
Remote control
light emitting areas
2 in (50 mm)
2 in
(50 mm)
2 in (50 mm)
3.9 in
(100 mm)