Operation Guide

Troubleshooting

When a connection is made using EasyMP Network Projection, the projected image remains as it is, and a connection

cannot be made from another computer.

Cannot select or change the connection mode.

Are the access point and the projector's subnet different?

(Advanced Connection Mode only)

Select Manual search from EasyMP Network Projection, specify the IP address, and connect.

Have you enabled DHCP? (Advanced Connection Mode

only)

When DHCP is set to On in Advanced Connection Mode, it may take some time to enter LAN standby

status if an available DHCP server is not found.

Check Remedy

Did the presenter leave the conference room without

cutting off the network connection?

With EasyMP Network Projection, the computer currently connected can be disconnected when

another computer tries to connect to the projector.

Therefore, when a Projector Keyword is not set for the projector, or if you know the Projector

Keyword, you can disconnect the computer currently connected and then connect your computer to

the projector.

When a Projector Keyword is set for the projector and you do not know the Projector Keyword, restart

the projector and reconnect.

Check Remedy

Is EasyMP Network Projection set to start up using the

same connection mode?

Select Display Connection Mode Selection window on startup on the General settings tab from

Set options. The projector selection screen is displayed after restarting EasyMP Network Projection.

Check Remedy