Operation Guide

Create new projector (auto registration)/Create new projector (manual

registration)/Edit Projector screen

You can display these screens by performing one of the following operations.

• To display the Create new projector (manual registration) screen, click Manual Registration on

the Edit Projector List screen.

• To display the Create new projector (auto registration) screen, select a projector that was found

using Auto Registration on the Edit Projector List screen, and then click Edit.

• To display the Edit Projector screen, select a projector on the Edit Projector List screen, and then

click Change.

The screenshots used in this section are for the Create new projector (manual registration) screen,

however the screens are the same for the other procedures.

1 Display name Enter the name of the projector. This name is displayed in the

projector list. You can enter up to 32 characters.

2 Projector name Displays the name that has been registered to the projector.

3 IP address Enter the projector's IP address when searching for a projector

manually. You cannot enter an IP address when editing or changing

information for a projector that has already been registered.

4 Monitor Password If a password has been set for the projector, enter the password

here. If you do not enter the correct password, you cannot update

the projector's firmware or copy the menu settings, even after

registering the projector. For more information about passwords,

see the User's Guide supplied with the projector.