User's Manual
Should you need to reset your computer, there are
three different ways to reset the Apex. Because each
one is more powerful than the last, try them in the
order listed here:
1. If you are using MS-DOS, hold down the
Ctrl and
Alt keys and press the Del key, which you can find
on the numeric keypad at the right of the
keyboard. You see the screen go blank for a
moment and then MS-DOS is loaded. (MS-DOS
must be on the system diskette in the top drive.) If
this does not correct the problem you’re having,
try the second method.
2. Press the RESET button on the front panel.
This method works even when the keyboard does
not respond to your commands. However, if this
does not correct the problem, try the third
method.
3. Remove any diskettes from the disk drives. Turn
off the monitor and any peripherals, and then turn
off the Apex. Wait for five seconds, and then
switch the power back on.
2-6
Using
Your Apex