User`s manual

• One edge of the ribbon cable is marked with a color line.
This specific line side of the connector should be at pin 1
when attached to the card. Pin 1 is clearly marked on the
card. See the figure below:
To Pin 1 of FDC Connector
To Drive A,
To Pin 1 of HDC Connector
To Drive D
Figure 6-5: Cables for Disk Drives
Follow the same procedure for any additional drives you want to install.
Removal
To remove a drive, just reverse the procedure described above. Dis-
connect the cables, undo the screws and slide the drive out.
Chapter 6: Appendix 5