User`s manual

Pressing <ESC> to Enter the Setup Program
lf you want to set up special functions provided by BIOS or reconfigure
your system, you will need to enter the setup program. After starting
your computer, press the <E
SC> key quickly before the RAM test
finishes.
lf you miss the chance to do so, reset your system and repeat
the above procedures to enter the setup program. Before the setup
program appears, the following message will appear on the screen:
SETUP utility will be starting
When the system self test is completed, the setup program will fake
over.
Once you have entered the setup program, you will see the following
initial screen:
ROM SETUP PROGRAM VERSION 2.0
(C) COPYRIGHT DATATECH ENTERPRISES CO., LTD 1990.
ALL RIGHTS RESERVED.
1. SET UP SYSTEM COFIGURATION.
2. PREFORMAT HARD DISK.
3. SET UP BUILT-IN UTILITY.
4. SET UP PASSWORD.
5. SET UP USER-DEFINED HARD DISK TYPE.
6. SET UP SHADOW RAM.
9. QUIT SETUP PROGRA
M.
CHOOSE ITEM NUMBER : [l]
Figure 3-1: Initial Screen
Chapter 3: Operating Your System
13