User`s manual

3-7 Setup Program

A system setup program included in your BIOS is used to set up your

system hardware.

Specifically, you can set the date, time, base

memory, extended memory, number of floppy/hard disk drives and

display configuration.

The setup program is simple to use: follow the instructions on the

screen as they appear. if you want your computer to function normally,

you should respond correctly to the screen prompts.

Entering the Setup Program

There

are several ways to

enter

the setup program.

Pressing <F1>, to Enter the Setup Program

You will need to press <Fl> to enter the setup program when:

• your computer is turned on for the first time

• the non-rechargeable battery is dead

• the hardware configuration is changed

lf the battery for CMOS chip is dead or the system configuration does

not match your actual hardware configuration, you will have to recon-

figure your system. The computer will give you this screen message:

Press the F1 key to enter the setup program or

press any other key to continue

Under the above conditions, pressing

<F1>

will automatically start the

setup program.

Using the DOB DEBUG Command to Enter the Setup Program

A> DEBUG <Enter>

-g=F000:FF60 <Enter>

This command will start the setup program.

Chapter 3: Operating Your System