User`s manual

Functions of Connectors and Jumpers

A variety of connections can be made from the mainboard to a control

panel on the front of your system. Following is a brief explanation of

the various functions of the connectors that the mainboard supports:

Reset Connector (Jumper J1)

This connector connects the reset switch to your control panel. If you

encounter any problems while using unfamiliar software, you can

always restart from the beginning by pressing the reset button. Note,

however that any data which have not been saved to a disk will be lost.

Turbo LED Connector (Jumper J2)

Jumper J2 is used to enable the Turbo LED. The Turbo LED in the

hardware switch indicates operation in the Turbo mode.

Chapter 2: Setting Up Your System