User`s manual

6-1 Installing Disk Drives

Up to three 5.25” floppy/hard disk drives and one 3.5” hard disk drive

may be installed in the system unit. Installation of a hard disk drive is

essentially similar to that for a floppy disk drive.

You may sometimes want to add to or exchange your floppy or hard

disk drives. Be certain to refer to the manuals for both the disk drive

and the controller card for any additional specific information.

In order to begin the installation, you should open the system unit case

as described on Figure 2-18. Then, refer to the two steps for fastening

disk drives and connecting cables on following pages.

However, if you want to remove disk drives, you would just reverse the

procedures to meet your needs.

Chapter 6: Appendix