User`s manual

2. Preformatting Hard Disk
If you want to preformat your herd disks, reenter the setup program by
pressing <Esc>, end select item 2 on the initial screen. The program
will then proceed es below:
ROM SETUP PROGRAM VERSION 2.0
(C) COPYRIGHT DATATECH ENTERPRISES CO., LTD 1990.
ALL RIGHTS RESERVED.
1. SET UP SYSTEM CONFIGURATION.
3. SE
PREFORMAT HARD DISK
4. SE
1. DRIVE TO PREPORMAT (C,D)
: [ C ]
5. SE
2. INTERLEAVE RATE (1,2,3)
:[ 3 ]
3. BUILD BAD TRACKS TABLE
: [ 0 ]
6.
SE
4. BEGIN TO PREFORMAT.
9. QU
SELECTION [5]
-------------------------------------------------.
CH
›œ ›œ :CHANGE ITEM
8 8 :ACCEPT
Figure 3-3: “Preformat Hard Disk” Screen
16 Chapter 3: Operating Your System