User`s manual

Entering the Setup Program
There are two ways to enter the setup program: by pressing <F1> or
by pressing <Esc> .
1. Pressing <F1> to Enter the Setup Program
You will need to press <F1>, to enter the setup program in the following
situations:
•
when your computer is turned on for the first time
•
when the rechargeable battery is dead
•
when the hardware configuration is changed
If the battery for CMOS chip is dead or the system configuration does
not match your actual hardware configuration, you will have to recon-
figure your system, The computer will give you this screen message:
Press the Fl key to enter the setup program or
press any other key to continue
Under the above three conditions, pressing <F7> will automatically
start the setup program.
Under any conditions within DOS, you can use the DOS DEBUG
command as follows:
A> DEBUG
-g=F000:FF60
This command will start the setup program.
12
Chapter 3: Operating Your System