User`s manual

Step 2: Connecting Cables

After fastening the disk drive, you will connect it with one power cable

and with its controller cable(s). Refer to the following instructions and

Figures 6-5, 6-6, and 6-7.

Floppy Disk Drives:

•

Connect the power cable:

You should connect the disk drive with one of the four

cables from the power supply. There is only one possible

way to connect with it owing to the shape of its connectors.

So it is impossible to make a mistake.

• Connect the controller cable:

One edge of the cable is marked with a color line. This

specific line side of the connector should be at pin 1 when at-

tached to the FDC/HDC card. Pin 1 is clearly marked on the

card. Refer to the following figure.

Figure 6-5: Controller Cab/e for the Floppy Disk Drive

Chapter 6: Appendix