User`s manual

3.5” Hard Disk Drive:
Your 3.5” disk drive must be a hard one, because it is a hidden style.
It cannot be slidden into the disk drive bay directly from the front panel
as a 5.25” disk drive. It must always be installed inside the system unit
case. Refer to the procedures below.
• Screw the lower metal guide to the disk drive as show below.
Figure 6-3: Screwing a 3.5” Hard Disk Drive
• Put it in the 3.5” disk drive bay by hanging it on the two
hooks which are located on the left side of the 5.25” disk
drive bays.
• Fasten it to the chassis by screwing. Refer to the figure.
Figure 6-4: Fastening the 3.5” Hard Disk Drive
4 Chapter 6: Appendix