Wuxi Weida Intelligent Electronics Co., Ltd.
Wuxi Weida Intelligent Electronics Co., Ltd. 遙控器功能需求說明 Remote control physical function requirements description 1.Button function description N0.
Wuxi Weida Intelligent Electronics Co., Ltd. 15 Google play 2.
Wuxi Weida Intelligent Electronics Co., Ltd.
Wuxi Weida Intelligent Electronics Co., Ltd. Remote control instructions 1.遙控器的特殊要求 1. Special requirements for remote control 1） 藍牙連接時，遙控器發送藍牙鍵值； 如果未連接藍牙，則發送紅外鍵值。 1）When Bluetooth is connected, the remote control sends the Bluetooth key value; if Bluetooth is not connected, the infrared key value is sent. 2） 指示燈：紅色，每按一次按鍵，指示燈閃爍 2) 低電壓提醒：當電池電量低時，指示燈快速閃爍。 只要它還在運行，它 就會一直保持在閃爍狀態。 當不再被遙控器操作時，它會閃爍 5 次或閃爍 3 秒，然後停止並熄滅。 2)Indicator light: red, each time the button is pressed, the indicator light flashes.
Wuxi Weida Intelligent Electronics Co., Ltd. 金鑰配對成功後，直到下次按鍵時才能發送配對廣播。 4）Pairing method: a) Press and hold the “ENTER” + “VOL-” button for 3 seconds at the same time, the indicator light flashes, and the pairing success indicator light is on for 3 seconds and then off. b) When the pairing is not successful, if you still press the ENTER +VOL- button, the pairing broadcast will be sent all the time so that the user can pair. c) Press the ENTER +VOL- button once to match successfully.
Wuxi Weida Intelligent Electronics Co., Ltd. 置 2 小時回連等，請驗證 50 次確保無問題； 2). Reconnection function requirements: there must be no problems with the connection failure, including the box power failure and the connection, the remote control power failure and the connection, stand for 2 hours to reconnect, etc., please verify 50 times to ensure that there is no problem; 3).抗干擾功能要求：不得存在非常影響主機 WIFI 輸送量的問題，請確保連接遙控器時 主機端 WIFI 輸送量正常； 3).
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
IC Warning This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme aux CNR exemptes de licence d'Industrie Canada .
