User`s guide

Status/Error/Warning INDICATOR LIGHTS
Ready Error
“Installed Developer Cartridge is Not a Genuine Epson Product Warning” on page 94
OFF
“Sleep mode” on page 95
OFF
“Ready” on page 95
OFF
“Printing” on page 95
OFF
“Processing Data” on page 95
OFF
Note:
If the problem remains after trying the suggestions in this section, contact your dealer or a qualified
service representative for assistance.
Service Required (controller error)
Control panel: Error light on
A controller error has been detected. Turn off the printer, wait 5 seconds and then turn it back on.
If all the lights come on again, turn off the printer, unplug the power cord, and contact a qualified
service representative.
Service Required (engine error)
Control panel: Ready and Error lights flashing
A print engine error has been detected. Turn off the printer, wait 5 seconds and then turn it back
on. If the lights come on again, turn off the printer, unplug the power cord, and contact a qualified
service representative.
Service Required (protocol error)
Control panel: Ready light flashing, Error light on
A protocol error has been detected. Turn off the printer, wait 5 seconds and then turn it back on. If
the lights come on again, turn off the printer, unplug the power cord, and contact a qualified
service representative.
EPSON AcuLaser M1200 Series User’s Guide
Troubleshooting 90
Downloaded from ManualsPrinter.com Manuals