User`s guide

SUPPLIES

REPLACE

FUSER UNIT Replace the counter when the fuser unit is replaced with

new one.

This menu item appears when ADMIN. MANAGEMENT/NETWORK SETTING/TCP/IP is set to ENABLE.

This menu item appears when ADMIN. MANAGEMENT/NETWORK SETTING/IPv6/DISABLE/ENABLE is set to ENABLE.

This menu item appears when ADMIN. MANAGEMENT/E-MAIL SETTING/POP BEFORE SMTP/DISABLE/ENABLE is set to

ENABLE.

This menu item appears when ADMIN. MANAGEMENT/E-MAIL SETTING/SMTP AUTH./DISABLE/ENABLE is set to

ENABLE.

This menu item appears when ADMIN. MANAGEMENT/LDAP SETTING/DISABLE/ENABLE is set to ENABLE.

COPY SETTING Menu

Note:

Manufacturer’s default settings appear in bold.

PAPER PRIORITY Settings

TRAY1 / TRAY2 / TRAY3

Specify the paper tray that is normally used.

Note:

If an optional 500-Sheet Paper Cassette Unit is not installed, TRAY3 does not appear.

TRAY CHAINING Settings

DISABLE / ENABLE

If ENABLE is selected and the specified tray runs out of paper during printing, a tray

loaded with paper of the same size is automatically selected so printing can continue.

If DISABLE is selected and the specified tray runs out of paper, printing stops.

QUALITY PRIORITY Settings

MIX / TEXT / PHOTO / FINE/MIX / FINE/TEXT / FINE/PHOTO

Select the type of document being copied.

Note:

❏ When a document is loaded into the ADF, the default setting MIX is automatically

selected.

❏ For the resolution of each setting, refer to “Resolution of QUALITY PRIORITY

Settings” on page 64.

DENSITY PRIORITY Settings

AUTO / MANUAL

Select the density that is normally used.

Epson AcuLaser CX37 Series Printer/Copier/Scanner User’s Guide

Control Panel and Configuration Menu 63