User`s guide

❏ You will hear a click when the DIMM is properly placed.
6. Attach the cover, and then tighten the screw.
7. Close the rear cover.
8. Reconnect all interface cables.
9. Reconnect the power cord, and turn on the machine.
10. Declare the additional memory in the Windows printer driver (Properties/Configure tab).
11. Print a configuration page (REPORT/STATUS/REPORT/CONFIGURATION PAGE) and verify that the
total amount of the RAM installed in this machine is listed.
Hard Disk Drive (C12C824511)
If you install a Hard Disk Drive, the followings can be performed:
❏ Job printing/saving
❏ Fonts/forms/color profile download
❏ User Authentication
❏ Direct printing
❏ Collate printing
Installing the Hard Disk Drive
Note:
It’s very important to protect the printer controller board and any associated circuit boards from
electrostatic damage. Before performing this procedure, see “Antistatic Protection” on page 236. In
addition, always handle circuit boards by the edges only.
1. Turn off the machine and disconnect the power cord and interface cables.
Epson AcuLaser CX37 Series Printer/Copier/Scanner User’s Guide
Installing Accessories 239