User`s guide

1. In the main screen (Scan mode), press the u or d key to select UTILITY, and then press the Select
key.
2. Press the u or d key to select DIAL REGISTER, and then press the Select key.
3. Press the u or d key to select SPEED DIAL, and then press the Select key.
4. Use the keypad to type in the number (between 1 and 220) for the speed dial destination, and then
press the Select key.
5. Press the u or d key to select LDAP SEARCH, and then press the Select key.
Note:
If an LDAP server is not specified, LDAP SEARCH does not appear.
6. Press the u or d key to select NAMEor E-MAIL, and then press the Select key.
Note:
To search registered names, select NAME. To search e-mail addresses, select E-MAIL.
7. Use the keypad to type in the search keyword (maximum of 10 characters), and then press the
Select key.
The search begins, and the search results appear after a while. If no data matches the search
keyword, NOT FOUND appears for about two seconds.
Note:
❏ For details on entering/editing text, refer to Facsimile User’s Guide.
❏ Text starting with the first character of the maximum 10 characters is searched for. Text will not
be found if the search keyword is in the middle of a word.
8. Press the u or d key to select the desired data, and then press the Select key.
Note:
❏ To check the found information, press the r key.
❏
An e-mail address exceeding 64 characters cannot be specified. If such an e-mail address is
specified, ADDRESS IS TOO LONG appears for about two seconds, and then the screen for
specifying the destination address appears.
❏ To narrow down the search results, press the Back key, and then perform step 7 again.
Epson AcuLaser CX37 Series Printer/Copier/Scanner User’s Guide
Using the Scanner 158