Operation Manual

19. Ensure that the message This Setting Becomes Effective after Restart appears, and
then press any button.
20. Press the
button to select Gateway Address, and then press the button.
The cursor is located at the first octet of the gateway address.
21. Enter the value of the gateway address using the numeric keypad.
22. Press the
button.
The cursor moves to the next octet.
23. Repeat steps 21 to 22 to set gateway address, and then press the
button.
24. Ensure that the message This Setting Becomes Effective after Restart appears, and
then press any button.
25. Turn off and turn on the printer.
See Also:
“Operator Panel” on page 28
Verifying the IP Settings
You can confirm the settings by printing the system settings report or using the ping command.
The following procedure uses Windows XP as an example.
1. Print the System Settings page.
2. Look under the IPv4 heading on the System Settings page to ensure that the IP address, subnet
mask, and gateway are appropriate.
To verify if the printer is active on the network, run the ping command in your computer:
1. Click start, and select Run.
2. Enter cmd, and then click OK.
A black window is displayed.
Epson AcuLaser CX29 Series User’s Guide
Network Basics 64