Operation Manual

3. Select Admin Menu, and then press the button.
4. Select Wired Network, and then press the
button.
5. Select TCP/IP, and then press the
button.
6. Select IPv4, and then press the
button.
7. Select Get IP Address, and then press the
button.
8. Select Panel, and then press the
button.
9. Ensure that the message This Setting Becomes Effective after Restart appears, and
then press any button.
10. Press the
button to select IP Address, and then press the button.
The cursor is located at the first octet of the IP address.
11. Enter the value of the IP address using the numeric keypad.
12. Press the
button.
The cursor moves to the next octet.
13. Repeat steps 11 to 12 to set all of the digits in the IP address, and then press the
button.
14. Ensure that the message This Setting Becomes Effective after Restart appears, and
then press any button.
15. Press the
button to select Subnet Mask, and then press the button.
The cursor is located at the first octet of the subnet mask.
16. Enter the value of the subnet mask using the numeric keypad.
17. Press the
button.
The cursor moves to the next octet.
18. Repeat steps 16 to 17 to set subnet mask, and then press the
button.
Epson AcuLaser CX29 Series User’s Guide
Network Basics 63